Ktl-icon-tai-lieu

Mạng ASi

Được đăng lên bởi nhoctibietyeu
Số trang: 64 trang   |   Lượt xem: 552 lần   |   Lượt tải: 1 lần
Preface, Contents

AS-Interface (AS-i)

SIMATIC NET
The AS-i Master

AS-Interface – Introduction and
Basic Information

Further AS-i System Components
The Master Mode – Commands, Sequence, Programming

1
2
3
4

Manual

Appendix

AS-Interface

Industrial Ethernet

PROFIBUS

AS-Interface

12/99
C79000-G8976-C089
Release 03

References

A

Glossary

B

SIMATIC NET – Support and Training

C

Safety Guidelines
This manual contains notices which you should observe to ensure your own personal safety, as well as to
protect the product and connected equipment. These notices are highlighted in the manual by a warning
triangle and are marked as follows according to the level of danger:

!
!
!

Danger
indicates that death, severe personal injury or substantial property damage will result if proper precautions
are not taken.

Warning
indicates that death, severe personal injury or substantial property damage can result if proper precautions are not taken.

Caution
indicates that minor personal injury or property damage can result if proper precautions are not taken.

Note
draws your attention to particularly important information on the product, handling the
product, or to a particular part of the documentation.

Qualified Personnel
Only qualified personnel should be allowed to install and work on this equipment. Qualified persons are
defined as persons who are authorized to commission, to ground, and to tag circuits, equipment, and systems in accordance with established safety practices and standards.

Correct Usage
Note the following

!

Warning
This device and its components may only be used for the applications described in the catalog or the
technical description, and only in connection with devices or components from other manufacturers which
have been approved or recommended by Siemens.
This product can only function correctly and safely if it is transported, stored, set up, and installed
correctly, and operated and maintained as recommended.

Trademarks
SIMATICR, SIMATIC HMIR and SIMATIC NETR are registered trademarks of the SIEMENS AG.
Third parties using for their own purpose any other names in this document which refer to trademarks
might infringe upon the rights of the trademark owners.

Copyright E Siemens AG 19989All rights reserved

Disclaimer of Liability

The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created b...
Preface, Contents
AS-Interface (AS-i)
1
The AS-i Master
2
Further AS-i System Components
3
The Master Mode – Commands, Se-
quence, Programming
4
Appendix
References
A
Glossary
B
SIMATIC NET – Support and Trai-
ning
C
12/99
C79000-G8976-C089
Release 03
AS-Interface – Introduction and
Basic Information
Manual
SIMATIC NET
Industrial Ethernet
PROFIBUS
AS-Interface
AS-Interface
Mạng ASi - Trang 2
Để xem tài liệu đầy đủ. Xin vui lòng
Mạng ASi - Người đăng: nhoctibietyeu
5 Tài liệu rất hay! Được đăng lên bởi - 1 giờ trước Đúng là cái mình đang tìm. Rất hay và bổ ích. Cảm ơn bạn!
64 Vietnamese
Mạng ASi 9 10 692